INSTALLATION DEGXEL HEATER with PACK n°1 B

If you have acquired the pack n°2 : click here

If you have acquired the pack n°3 : click here

If you have acquired the pack n°4 : click here

SOCKET controlled by wireless thermostat

Hang up the heater on the wall according to the instructions in the supplied manual. Identify a standard electrical outlet (16A, 230V, grounded).

Thermostat: With a flat screwdriver, carefully open the front case of the thermostat to reveal the batteries. Remove the blue cover so that the thermostat can be switched on. Close the cover.

Insert the radio socket unit into a wall socket. Plug the heater plug in the radio socket.

PS: There is no pairing operation to be performed as this step has already been carried out at the factory.

The only 2 useful buttons are the + and – to adjust the set temperature.

This model of thermostat does not allow programming and controls a single heater. Its only function is to switch the heater on or off depending on the ambient temperature.

If the set temperature is higher than the room temperature, after a few seconds you will hear a “CLAC”, the plug will power the heater and it will start to heat up in the next few minutes (3-4 minutes to feel that the surface of the heater starts to heat up).

If the set temperature is lower than the room temperature, after a few seconds you will hear a “CLAC”, the plug will be switched off and the heater will stop heating.